Wechat: 13869171699
English
pусский
Chinese
    Información
    How the pressure gauge is installed
    How the pressure gauge is installed
    2025-03-07
    Pressure gauge national standard "General Pressure Gauges" GB/T1226-2001 in No. 4.1.2 instruments are divided into direct installation pressure gauges, embedded (disc) pressure gauges, and convex (wall-mounted) pressure gauges according to threaded joints and installation methods.1. The in
    The main structure of the pressure gauge
    The main structure of the pressure gauge
    2025-03-07
    Overflow hole:In the event of an emergency such as a Bourdon tube burst, the internal pressure will be released to the outside through the overflow hole to prevent the glass panel from bursting. Note:In order to maintain the normal performance of the overflow hole, it is necessary to lea
    Basic Terms of Pressure Gauges
    Basic Terms of Pressure Gauges
    2025-03-06
    1. Positive Pressure and Negative Pressure2. Relative Pressure and Absolute Pressure3. Vacuum Degree4. Methods of Pressure Representation5. There are two ways to express pressure: one is the pressure expressed with absolute vacuum as the reference, called absolute pressure; the other is the pressure
    Precautions when using the pressure gauge
    Precautions when using the pressure gauge
    2025-03-06
    1. The instrument must be vertical: a 17mm wrench should be used to tighten it during installation, and the case should not be twisted strongly; Collisions should be avoided during transportation;2. The instrument should be used in the surrounding environment temperature of -25~55 °C;3. The vibrati
    Overload issues
    Overload issues
    2025-03-05
    The power required for the roots vacuum pump to compress the gas is directly proportional to the pressure difference, once the gas pressure difference is too high, the pump may be overloaded, causing the motor windings to burn out. There are several ways to solve the problem of pump overload:(1) Ado
    The main causes of internal air leakage in roots pumps include
    The main causes of internal air leakage in roots pumps include
    2025-03-05
    The speed of the pump is not enough, and the sealing is not tight, such as air leakage at the connection of the inlet pipeline or shaft seal, the gap between the rotor and the rotor, the outer ring of the rotor and the pump casing, the end face of the rotor and the end cover, the ambient temperature
    Requirements for on-site installation of roots blower
    Requirements for on-site installation of roots blower
    2025-03-04
    1. Installation siteThere should be a safe passage position no less than 1.5-2 meters around the fan. The operating ambient temperature of the fan shall not exceed 40 degrees Celsius. When the fan is installed indoors, it should ensure that the machine room has sufficient lighting, dry air and good
    Blower applications
    Blower applications
    2025-03-04
    The function of the blower is to evenly enter the impeller through the air intake chamber, and after the centrifugal force and the diffuser effect in the impeller in the rotating blades, the gas obtains pressure energy and speed energy, and the gas flowing out of the impeller at high speed is conver
    ···7891011···

    Enlace rápido

    Producto

    Greentech International (Zhangqiu) Co., Ltd.

    Llámanos.

    - llámanos.

    +86-531-83117088

    Correo electrónico:   greentech@vip.163.com

    Dirección: Mingshui Economic Development Zone, Zhangqiu, Jinan City, Shandong, China

    Skype: guanglin_jiang

    Copyright © 2020  Green Science and Technology International (capítulo) Co.  | Derecho de autor