Wechat: 13869171699
English
pусский
Chinese
    Información
    Precautions when using the pressure gauge
    Precautions when using the pressure gauge
    2025-03-06
    1. The instrument must be vertical: a 17mm wrench should be used to tighten it during installation, and the case should not be twisted strongly; Collisions should be avoided during transportation;2. The instrument should be used in the surrounding environment temperature of -25~55 °C;3. The vibrati
    Overload issues
    Overload issues
    2025-03-05
    The power required for the roots vacuum pump to compress the gas is directly proportional to the pressure difference, once the gas pressure difference is too high, the pump may be overloaded, causing the motor windings to burn out. There are several ways to solve the problem of pump overload:(1) Ado
    The main causes of internal air leakage in roots pumps include
    The main causes of internal air leakage in roots pumps include
    2025-03-05
    The speed of the pump is not enough, and the sealing is not tight, such as air leakage at the connection of the inlet pipeline or shaft seal, the gap between the rotor and the rotor, the outer ring of the rotor and the pump casing, the end face of the rotor and the end cover, the ambient temperature
    Requirements for on-site installation of roots blower
    Requirements for on-site installation of roots blower
    2025-03-04
    1. Installation siteThere should be a safe passage position no less than 1.5-2 meters around the fan. The operating ambient temperature of the fan shall not exceed 40 degrees Celsius. When the fan is installed indoors, it should ensure that the machine room has sufficient lighting, dry air and good
    Blower applications
    Blower applications
    2025-03-04
    The function of the blower is to evenly enter the impeller through the air intake chamber, and after the centrifugal force and the diffuser effect in the impeller in the rotating blades, the gas obtains pressure energy and speed energy, and the gas flowing out of the impeller at high speed is conver
    Performance characteristics of roots pumps
    Performance characteristics of roots pumps
    2025-03-03
    Fast start, less power consumption, low operation and maintenance costs, large pumping speed, high efficiency, insensitive to a small amount of water vapor and dust contained in the pumped gas, large pumping rate in the pressure range of 100~1 Pa, can quickly eliminate the sudden release of gas. Thi
    The use and operation of the blower
    The use and operation of the blower
    2025-03-03
    (1) Check the lubricating oil level of the oil tank, which should be between the upper and lower limits of the oil dipstick(2) Notify the substation to supply power to the machine(3) Check the control cabinet on the machine, there should be no alarm display, if there is an alarm, find out the cause
    Common faults of roots pumps
    Common faults of roots pumps
    2025-02-28
    1. The starting pressure of the roots pump is too high, which causes the parts of the pump to overheat and be damaged (some mechanical booster pumps can also be started under atmospheric pressure after special design).2. The large abrasive particles generated in the production process enter the root
    ···4445464748···

    Enlace rápido

    Producto

    Greentech International (Zhangqiu) Co., Ltd.

    Llámanos.

    - llámanos.

    +86-531-83117088

    Correo electrónico:   greentech@vip.163.com

    Dirección: Mingshui Economic Development Zone, Zhangqiu, Jinan City, Shandong, China

    Wechat / Whatsapp: 13869171699

    Copyright © 2020  Green Science and Technology International (capítulo) Co.  | Derecho de autor